- Excellent Equipment TechnologyHumanized Operation Design
customer
service hotline 18995984321
service hotline 18995984321
How to maintain the rock cutting machine? Is there any correct maintenance method? |
| 發(fā)布：2022/3/2 來源： 作者： 瀏覽：659次 |
| When it comes to equipment, in addition to use, it is daily maintenance. Moreover, daily maintenance is very important. In this link, we pay attention to both methods and methods. So, how do we maintain the rock plate cutting machine equipment? Is there any correct maintenance method? 01. Do not place the instrument in an uneven or vibrating place. 02. When changing water in the water tank, please do not pull out the power connector of the water pump with wet hands. Do not allow the water pump cable or connector to be stained with water to avoid electric shock injury. 03. The equipment manufacturer of rock plate cutting machine said that when using two water tanks, it is necessary to check whether the water in the clean water tank is sufficient and whether the water in the dirty water tank overflows quickly. 04. Check whether the sealing rubber of the suction cup is damaged. If so, please replace it with a new one. Because the powder accumulated in the crack will scratch the lens, and also cause the lens center and axis offset. 05. When cleaning the machine, be sure not to let the cleaning fluid enter the interior of the machine and the control panel, so as to avoid component corrosion, damage or short circuit of electronic components. 06. When dressing the grinding wheel, pay attention not to touch the grinding wheel with your fingers. 07. In some machines, the grinding wheel for grinding resin sheets cannot be trimmed. 08. If the grinding wheel of rock plate cutting machine continuously trims the same position, there will be concave grooves, which cannot be repaired. The above refers to "how to maintain the rock cutting machine? Is there any correct maintenance method?" If you don't understand or don't understand these contents, you can ask us at any time. Thank you for your attention. |
| 【字體：大 中 小】 【關(guān)閉窗口】 |
| Disclaimer: if the content is similar or infringed, please notify us in time and thank you for your support |
| 上一篇：What problems are likely to occur when the manufacturer of rock plate cutting machine … 下一篇：How much is the circular arc small rock cutting machine? What if the cutting machine b… |
TIME: 2022/3/2 9:38:464
TIME: 2022/3/2 9:38:104
TIME: 2022/3/2 9:37:304
TIME: 2022/3/2 9:36:504
TIME: 2022/3/2 9:35:574
鄂公網(wǎng)安備 42900402000365號
鄂ICP備2022002751號-1
Home Page
Telephone
short message